The pedal on an E-MTB is of course freely selectable, since there are no requirements on the part of the legislator. But the requirements for the pedal are different due to higher and more frequent loads when used in electrical operation. Trails that you could previously climb into the mountains only by highlighting all your driving skills become easier to master with the help of the engine. It often does not remain to catch one or another obstacle that gets in the way with the pedals and this leads to unsightly contacts. That's why we've reinforced our proven Escape pedal in the right places to achieve even more stability. Our E-Escape pedal has been designed for heavy use. Selected steel pins with a height of 5mm provide super support and are extra strong. The pin design also prevents damage to the pedal body thread in case of possible replacement of worn pins. Safety Note: Unless otherwise stated by the crank manufacturer. Make sure the pedals with minimum 37 to max. 42 Nm is tight. Specifications: Pedal size: 100 x 100 mm. Pedal height: 16 mm. Pedal thread: 9/16 inches. Storage: 1 x industrial multi-joint bearing / 1 x IGUS GNI PIN Setup: 24 steel pins per pedal Pin height: 5 mm above pedal Weight: 431 g per pair (weight tolerance +/- 5%). Material: aluminium (pedal) / CrMo (shaft) IGUS extras Plain bearings and industrial multi-density bearings. Reinforced pedal body. Durable and easily replaceable steel pins. Minimum height for maximum ground clearance. Pedal washer (washer to protect the crankset). Interchangeable pins